看了FTIR傅里葉煙毒性分析儀的用戶又看了
虛擬號將在 180 秒后失效
使用微信掃碼撥號
Multicomponent FTIR Gas Analyzer
多組分傅里葉紅外光譜分析儀
Gasmet On-line Series includes industrial multicomponent gas analyzers for continuous monitoring applications. The Gasmet CX4000 incorporates a Fourier transform infrared spectrometer, a temperature controlled sample cell, and signal processing electronics. The analyzer is fully equipped for fixed installations and it offers versatility and high performance for all industrial users.
Gasme在線測試系列包括工業多組分氣體分析儀應用于連續在線監測領域。Gasmet CX4000 由傅里葉變換紅外光譜儀、 樣品溫度控制單元和信號處理電子系統組成。該分析儀為所有工業用戶提供多功能和高性能的成套裝備。
The Gasmet CX4000 is designed for continuous emission monitoring. It is an ideal tool to analyze trace concentrations of pollutants in wet, corrosive gas mixtures. The sample cell can be heated up to 180 °C. Sample cell absorption path length is selected according to the application.
Gasmet CX400分析儀是專門為檢測煙氣的連續排放而設計的。它是來分析潮濕的腐蝕性氣體混合物中痕量污染物濃度的理想工具。樣品池可以被加熱到180 ℃,吸收光譜樣品單元可根據客戶實際應用調整選擇。
The Gasmet CX4000 allows simple calibration using only single component calibration gases. The user can easily configure the analyzer for a new set of compounds.
Gasmet CX4000分析儀允許使用只組分標準氣體標定。使用者很容易配置新的測試氣體組分。
General parameters 常規參數
Measuring principle:Fourier transform infrared, FTIR
Performance:Simultaneous analysis of up to 50
gas compounds
Response time, T90:Typically < 120 s, depending on
the gas flow and measurement
Time
Operating temperature:5 - 30°C, non-condensing
air conditioning recommended
Storage temperature:-20 - 60°C, non-condensing
Power supply:100-115 or 230 V / 50 -60 Hz
Power consumption:300 W max, continuous 150
測量原理:FT-IR(傅里葉變換紅外光譜分析)
性能:可同時測量多達50種氣體組分
響應時間T90:< 120 s,取決于氣體流速和測量時間
工作溫度:5 - 30°C,無冷凝,建議使用空調以保持恒溫。
貯存溫度:-20 - 60°C,無冷凝
電源:100-115v or 230 V / 50 -60 Hz
功率:**功率為300W,連續工作功率為150W
Spectrometer 分光儀
Resolution:4 cm-1
Scan frequency:10 scans / s
Detector:Peltier cooled MCT
Source:SiC, 1550 K
Beamsplitter:ZnSe
Window material:ZnSe
Wave number range:500 - 4 200 cm-1
分辨率:4 cm-1
掃描頻率:10 次/s
檢測器:Peltier 制冷 MCT
紅外光源:SiC, 1550 K
分束器:ZnSe
窗口材質:ZnSe
波數范圍:500 - 4200 cm-1
Sample cell 樣品室
Structure:Multi-pass, fixed path length 5.0 m
Standard material:100 % rhodium coated aluminium
Mirrors:Fixed, protected gold coating
Volume:0.4 liters
Connectors:Inlet Swagelok 6 mm
Outlet Swagelok 8 mm
Gaskets:Viton® O-rings
Temperature:180 °C, maximum
Window material:BaF2
結構:多冊反射光程,固定路徑長度為5.0m
標準材質:100%銠鍍鋁
反射鏡:固定,黃金鍍層保護
容積:0.4L
連接器:入口接頭套管6mm,出口接頭套管8mm;
墊片:O型氟化橡膠
溫度:**180℃
窗口材質:BaF2
Measuring parameters 測量參數
Zero point calibration:24 hours, calibration with nitrogen (5.0 or higher N2 recommended)
Zero point drift:< 2 % of measuring range per zero point calibration interval
Sensitivity drift:None
Linearity deviation:< 2 % of measuring range
Temperature drifts:< 2 % of measuring range per 10K temperature change
Pressure influence:1 % change of measuring value for 1 % sample pressure change.Ambient pressure changes measured and compensated
零點校準:24H,用純N2校準(推薦用5.0或更高的N2)
零點漂移:< 2 %(小于每個零點的校準區間量程< 2 %)
靈敏度漂移:無
線性偏差:< 2 %(測量量程的2 %);
溫度漂移:每10K的溫度變化內漂移量<量程2%
壓力影響:樣氣壓力變化1%,測量值變化1%,環境壓力變化可被監測并得以補償。
Electrical connectors 電連接器
Digital interface:9-pole D-connector for RS-232 Analyzer is connected to an external computer via RS-232C cable. The external computer controls Gasmet.
Power connection:Standard plug CEE-22
數字接口:RS-232 D型9孔,分析儀通過 RS-232C 連接到外部計算機,由外部計算機控制傅立葉分析儀。
電源連接:CEE-22標準插頭
Gas inlet and outlet conditions 氣體進出口條件
Gas temperature:Non-condensing, the sample gas temperature should be the same as the sample cell temperature
Flow rate:120 - 600 liters per hour
Gas filtration:Filtration of particulates (2 μm) required
Sample gas pressure:Ambient
Sample pump:External, not included
氣體溫度:無凝結,樣氣溫度必須和樣品室的溫度相同
流速:120-600L/h
氣體過濾器:過濾精度2 μm
樣氣壓力:大氣壓
樣氣泵:外置,不包含
Electronics 電氣
A/D converter:Dynamic range 95 dB
Signal processor:32-bit floating point DSP 120 MFLOPS
Computer:External, not included
A/D轉換器:動態范圍:95 dB
信號處理器:32 bit浮點 DSP 120 MFLOPS
計算機:外置,不包含
Analysis software (for external PC)
Operating system:Windows 7 (32-bit)
Analysis software:Calcmet for Windows
分析軟件(外部計算機)
操作系統:Windows 7 (32位)
分析軟件:基于Windows的Calcmet
Options 選項
Pressure measurement:Inside sample cell
External PC:
Gasmet PC for control and analysis with optional alarm relay boards and analog inputs or outputs
Sample cell gaskets:Kalrez®
壓力測量:在樣品室內部
外置計算機:Gasmet工業電腦配備警報繼電器板和模擬信號輸入輸出接口,用于系統控制和信號分析。
Enclosure 附件
Sample cell material:Aluminium
Dimensions (mm):482 * 196 * 450
Weight:17 kg
CE label:According to EMI guideline 89/336/EC
樣品室材質:鋁
尺寸(mm):482 * 196 * 450
重量:17KG
CE標簽:據 EMI 89/336/ec 號指令
暫無數據!